Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Raye-limit on Cat 6500

I want to rate limit on a Vlan interface. are the following commands going to rate-limit what I want.

Conf t

Int vlan 1

Rate-limit input access-group 100 25000000 4687500 4687500 conform-action transmit exceed-action drop

Rate-limit output access-group 101 25000000 4687500 4687500 conform-action transmit exceed-action drop

exit

conf t

Access-list 100 permit ip any 205.141.209.128 255.255.255.128

Access-list 100 permit ip any 192.136.34.0 255.255.255.0

Access-list 100 permit ip any 205.142.126.0 255.255.254.0

Access-list 100 permit ip any 205.142.125.0 255.255.255.0

Access-list 101 permit ip 205.141.209.128 255.255.255.128 any

Access-list 101 permit ip 192.136.34.0 255.255.255.0 any

Access-list 101 permit ip 205.142.126.0 255.255.254.0 any

Access-list 101 permit ip 205.142.125.0 255.255.255.0 any

2 REPLIES
Cisco Employee

Re: Raye-limit on Cat 6500

6500s do not support rate limiting on VLAN interfaces. You need to use policing instead.

http://www.cisco.com/warp/public/473/102.html

New Member

Re: Raye-limit on Cat 6500

This Rate-limit would actually be put on the MFSC2. does that make a difference?

94
Views
0
Helpful
2
Replies
CreatePlease login to create content