Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Rcv-Err on Catalyst 2950G-48

Hi,

I am busy rolling out a new Ethernet LAN and when I do a ' show interface couters errors ' I seem to get a lot of Rcv-Err on certain interfaces.

Below is the output 3 hours after clearing the counters:

Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize

Fa0/43 81 75 0 1788 1458

Fa0/44 77 79 0 2894 2503

Could this be related to NIC card problems?

Regards

Dean

1 REPLY

Re: Rcv-Err on Catalyst 2950G-48

Undersize frames can be caused by collisions. Please check your speed & duplex settings.

Could also be a cabling issue.

148
Views
4
Helpful
1
Replies