Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RcvUNISeqMismatch

Hi!

Can please anyone tellme which could be the causes that the RcvUNISeqMismatch counters increase on a MGX82xx (UNI PORT), the most of the times i`ve seen for clocking issues, but this time is everything OK!!, we tested OK acces (both sides, SP & CPE), we checked also electrical grounding, etc..

Any ideas?

Thanks!!

1 REPLY
Bronze

Re: RcvUNISeqMismatch

Alfonso,

If my memory serves me, I believe this is caused by the MGX receiving the same sequence # in the status updates from the CPE. This is an indication that the CPE is not received updates from your UNI port. I would check the transmit direction from your port towards the CPE.

~Zach

140
Views
0
Helpful
1
Replies