06-29-2006 10:43 AM - edited 03-03-2019 03:52 AM
I just recently started to configure the 6509 and wanted to know if I routing is eabled by default. Also, I would like to enable vtp, spanning-tree and switchportt access. i am in the process of cutting over from a CATos 4k and 5k whcih is configured using a flat vlan configuration. Also, I this unit was pre configured by an other engineer which is no longer here. I would like to assing a management ip to the system/vlan interface which is normally on vlan10 which is now configured on vlan 1000
thanks in advance.
Thanks in advance.
06-29-2006 10:55 AM
I just recently started to configure the 6509 and wanted to know if I routing is eabled by default.
>> If you are running Native YES, if you are running Hybrid, obviously the MSFC will be the layer3 and it too will be haivng ip routing enbaled by default.
Also, I would like to enable vtp, spanning-tree and switchportt access. i am in the process of cutting over from a CATos 4k and 5k whcih is configured using a flat vlan configuration.
>> Flat vlan to me sounds like all the ports belong to the same vlan, if it was left alone then all will be in vlan 1.
Also, I this unit was pre configured by an other engineer which is no longer here. I would like to assing a management ip to the system/vlan interface which is normally on vlan10 which is now configured on vlan 1000
>> is this hydrid? set sc0 1000
native IOS >> interface vlan 1000
ip address
Hydrid (CatOS):
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_5/confg_gd/supcfg.htm
Native (IOS)- Configuring LAN Ports for Layer 2 Switching:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/layer2.htm
Please rate all posts.
06-29-2006 12:07 PM
B,
Thanks for the reply! This is running native IOS. I was unable to configure SC0 and SC1 due to the fact these interfaces were not available. Now that i would like to statically assign these ports to a vlan how can I enable swithport access and spanning tree. i wwill o thorugh the cco site to find this info.
Thanks again.
06-29-2006 12:26 PM
can I enable swithport access
A: create vlan either by config t
vlan x
or vlan database
vlan x
then interface blah x/x
switchport
switch access vlan x
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/vlans.htm
spanning tree.
A: The switch runs spanning-tree by default:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/spantree.htm
Please rate all posts.
06-29-2006 12:56 PM
I am recieving the a error "this is not a swithcing port"
Thanks.
-fz
06-29-2006 12:57 PM
Thanks!
06-29-2006 01:41 PM
Thanks B! It was a user error on my side...lol
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: