Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Re: Cat 6509

I just recently started to configure the 6509 and wanted to know if I routing is eabled by default. Also, I would like to enable vtp, spanning-tree and switchportt access. i am in the process of cutting over from a CATos 4k and 5k whcih is configured using a flat vlan configuration. Also, I this unit was pre configured by an other engineer which is no longer here. I would like to assing a management ip to the system/vlan interface which is normally on vlan10 which is now configured on vlan 1000

thanks in advance.

Thanks in advance.

6 REPLIES

Re: Re: Cat 6509

I just recently started to configure the 6509 and wanted to know if I routing is eabled by default.

>> If you are running Native YES, if you are running Hybrid, obviously the MSFC will be the layer3 and it too will be haivng ip routing enbaled by default.

Also, I would like to enable vtp, spanning-tree and switchportt access. i am in the process of cutting over from a CATos 4k and 5k whcih is configured using a flat vlan configuration.

>> Flat vlan to me sounds like all the ports belong to the same vlan, if it was left alone then all will be in vlan 1.

Also, I this unit was pre configured by an other engineer which is no longer here. I would like to assing a management ip to the system/vlan interface which is normally on vlan10 which is now configured on vlan 1000

>> is this hydrid? set sc0 1000

native IOS >> interface vlan 1000

ip address

Hydrid (CatOS):

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_5/confg_gd/supcfg.htm

Native (IOS)- Configuring LAN Ports for Layer 2 Switching:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/layer2.htm

Please rate all posts.

New Member

Re: Re: Cat 6509

B,

Thanks for the reply! This is running native IOS. I was unable to configure SC0 and SC1 due to the fact these interfaces were not available. Now that i would like to statically assign these ports to a vlan how can I enable swithport access and spanning tree. i wwill o thorugh the cco site to find this info.

Thanks again.

Re: Re: Cat 6509

can I enable swithport access

A: create vlan either by config t

vlan x

or vlan database

vlan x

then interface blah x/x

switchport

switch access vlan x

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/vlans.htm

spanning tree.

A: The switch runs spanning-tree by default:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/spantree.htm

Please rate all posts.

New Member

Re: Re: Cat 6509

I am recieving the a error "this is not a swithcing port"

Thanks.

-fz

New Member

Re: Re: Cat 6509

Thanks!

New Member

Re: Re: Cat 6509

Thanks B! It was a user error on my side...lol

131
Views
0
Helpful
6
Replies
CreatePlease to create content