07-10-2006 03:35 AM - edited 03-03-2019 03:58 AM
why would my isdn 30 router use this, I have a 32 bit route pointing to my dialler interface and then the network route pointing to the 32 bit route ?
cheers
07-10-2006 04:26 AM
Disable or Reenable Peer Neighbor Routes
The Cisco IOS software automatically creates neighbor routes by default; that is, it automatically sets up a route to the peer address on a point-to-point interface when the PPP IPCP negotiation is completed.
To disable this default behavior or to reenable it once it has been disabled, use the following commands in interface configuration mode:
Command Purpose
no peer neighbor-route
Disable creation of neighbor routes.
peer neighbor-route
Reenable creation of neighbor routes.
is that what you are after ?
07-10-2006 04:45 AM
this is not what i was loking for, they are just static routes !!
07-10-2006 08:59 PM
Hi Carl
can you be more clear & throw some more light with the config info which you are having over there ?
regds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: