Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

rebooting MSFC on a l3 switch

If I have a 4006 with a L3 module that isn't being used yet, but the layer2 sup and ethernet blades are being used for layer2 stuff, can I reload the layer3 module without affecting the rest of the switch?

1 REPLY
New Member

Re: rebooting MSFC on a l3 switch

Yes you can with the "reset x" command where "x" is the module number of the L3 module.

Keep in mind that this command will also shutdown all of the ports on that module until it comes back up.

-Mark

103
Views
0
Helpful
1
Replies
CreatePlease to create content