Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Receiving a "multilink bundle overload" error

In troubleshooting an ISDN circuit I get this on the dialer interface. After clearing the bri0 traffic is flowing, however, I still see this message. Some background and a remedy would help out.

1 REPLY
Anonymous
N/A

Re: Receiving a "multilink bundle overload" error

The message sounds like it is debug

output (although I'm not sure of the

exact syntax of the message that you

are seeing). It essentially means that

the load on an MPPP bundle is higher

than the load-threshold configured,

and so we will try to add another link

to the bundle.

You could either remove or increase the

load-threshold, or disable the debug.

161
Views
0
Helpful
1
Replies
CreatePlease to create content