Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reconfigure ASA outside interface

We recently upgraded our bandwidth and I have to change the ip address on our ASA 5510. I just want to make sure that I am doing it right. All I will need to do is open up the ASDM and under confiugration go to interfaces and make the needed changes to the outside interface. Then under routing I will make the gateway IP change on the outside interface. Am I missing anything?

4 REPLIES
VIP Purple

Reconfigure ASA outside interface

That depends on your version. If you are running v8.2 or earlier, then you also have to adjust your outside ACLs. And with all versions it could be needed to change your NAT-settings.


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
New Member

Reconfigure ASA outside interface

Yes, I plan on needing to make changes to both may ACL and my NAT settings.

Reconfigure ASA outside interface

Hi Sapper,

You need to change the IP address of the outside interface..... outside route to be pointed to the new gateway IP address.... NAT/PAT changes needs to be done if you have used IP address... If you have used interface then its not required..... ACL changes with respect to old IP range has to be adjusted if any.

Please do rate if the given information helps.

By

Karthik

New Member

Reconfigure ASA outside interface

Hi,

Also if you have any L2L VPNs setup you will need to update those with the new IP address.

348
Views
0
Helpful
4
Replies
CreatePlease to create content