Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

recover image

All,

I've accidently erase the flash and now everytime the router reboot. It giving me a promt of (rommon 3 >).

I've done alots of research but could't find anything.

This is what I've try..also the TFTP server is already running. I am stuck now..Please help me. Thankssss

rommon 1 > set

PS1=rommon ! >

BSI=0

IP_ADDRESS=192.168.0.4

IP_SUBNET_MASK=255.255.255.0

DEFAULT_GATEWAY=192.168.0.2

TFTP_SERVER=192.168.0.2

TFTP_FILE=c2600-ix-mz.122-2.BIN

TFTP_CHECKSUM=0

?=1

rommon 2 > tftpdnld

IP_ADDRESS: 192.168.0.4

IP_SUBNET_MASK: 255.255.255.0

DEFAULT_GATEWAY: 192.168.0.2

TFTP_SERVER: 192.168.0.2

TFTP_FILE: c2600-ix-mz.122-2.BIN

Invoke this command for disaster recovery only.

WARNING: all existing data in all partitions on flash will be lost!

Do you wish to continue? y/n: [n]: yes

.

TFTP error 1 received (File not found:f).

TFTP: Operation terminated.

rommon 3 >

4 REPLIES
Community Member

Re: recover image

well, your router could not find the file (soft)

- first, check that the name of the file is exact (the BIN word, try it bin, not capital letter)

-second, the tftp server is configurable, you must tell your tftp server what folder to use to find the file (soft)

hope this help

Community Member

Re: recover image

Thanks for the help but I 've try that and still doesn't work.

Community Member

Re: recover image

in the software advisor when i put : c2600-ix-mz.122-2.BIN

it returned : The image name you have searched for is either an invalid image name or the image is not supported by Software Advisor. Please check the image name or the list of supported Cisco IOS releases in the Help file.

so there is a mistake in the name of the soft

check the name or try an other one

Community Member

Re: recover image

All,

I found out that if do it through xmodem is more easy than through ethernet. By change the baud rate to 115200 and send the image from there. It working again now. Thanks for all the help...

103
Views
0
Helpful
4
Replies
CreatePlease to create content