If this is a lab node, use an NPM from a node that you know the password for and powerup the node with that NPM and insert the original NPM as standby so that configs are copied over. This way, you can loginto the IGX and then change the password.
If you do not have any of the userid's or passwords and the default userid's and passwords don't work , then the only way is the method I mentioned above.
Call TAC and provide dialin to check if the defaults work.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...