Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

fly
New Member

redistribute in ospf

|-----s4-----|

s1---trunk---s2

e0 e0

| |

---r3--------

topology as above

I config r1-r2 in ospf area 0. r1 e0 interface in area 0, and r2 e0 interface was not configured in area0.

when i redistribute static in R1, (static route point to R3).

I can't find redistributed route in r2,i can find external LSA in ospf database in R2, But R2 can't put it in routing table, when i config R2 E0 interface in area0 , redistribute route is put in routing table.

why?

4 REPLIES
Silver

Re: redistribute in ospf

Did you include the "subnets" under redistribution and different type of OSPF network ? e.g. E1 E2, etc. ?

Re: redistribute in ospf

Hello,

in addition to Jack's post, can you post the configurations of R1 and R2 ? Also, from your topology I cannot really tell how R1, R2, and R3 are physically connected, can you clarify ?

Regards,

GNT

fly
New Member

Re: redistribute in ospf

sorry, topology was mess,but it is simple. i can't upload picture.

s1----trunk--s2(e0)------r3

|--(e0)-----------------|

i include subnets key words.

thank you!

fly
New Member

Re: redistribute in ospf

s1----trunk--s2(e0)---r3

|--(e0)------------------|

156
Views
0
Helpful
4
Replies