I am thinking to increase my level of redundancy in my networkk using all the available Ethernet/Fast ethernet interface in the router used as default gateway from the LAN in the remote site (in an Hub and spoke configuration).
My problem is: How can I connect both ethernet interface of the router to the switch ports in the same LAN? I need one Logical interface and two physical interfaces under it.
I need something like Fastethernet Channel (FEC, but it is not available on routers (2600,3600 and 7200).
I do not want used Spanning Tree because in case of flapping the transition time is too long (45 sec).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.