Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Redundant WAN links config?

I am trying to set up a 1721 running 12.2(4) with a T1 WIC and an ethernet WIC. The T1 is running over a leased line with PPP encapsulation. The ethernet card will be connected to Cable modem. I need to set up NAT as well. I want to be able to use the T1 for everything until it goes down, then shift all traffic to the ethernet/cable modem. This is for highly available internet access only, no services being hosted inside private network. If you could point me in the right direction, I would be most appreciative.

Thanks,

Dave

  • Other Network Infrastructure Subjects
1 REPLY

Re: Redundant WAN links config?

You could use two static defaults.

ip route 0.0.0.0 0.0.0.0

ip route 0.0.0.0 0.0.0.0 50

50 is the administrative distance for the route via cable modem. Thiswill ensure that the route via cablemodem will be used only if t1 goes down.

Are both the t1 and cable mode from same service provider or different. You can use NAT with route maps to NAT to the appropriate service provider address space.

Check this link

http://www.cisco.com/warp/public/105/nat_routemap.html

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t4/ftnatrt.htm

81
Views
0
Helpful
1
Replies