Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Regarding changing Port from one VLAN to other VLAN in CISCO 4006 Catalyst

Respected Sir,

Do we have any command for Cisco Core 4006 with Supervisor Engine II through which we can change the port from one VLAN to another VLAN.

I tried to change the port using set VLAN , but still its showing same ports.

Here is the configuration :

WS-C4006 Software, Version NmpSW: 6.1(1)

Hardware Version: 3.2 Model: WS-C4006 Serial #: JAB05320D1C

Mod Port Model Serial # Versions

--- ---- ---------- -------------------- ---------------------------------

1 2 WS-X4013 JAB05320D1C Hw : 3.2

Gsp: 6.1(1.0)

Nmp: 6.1(1)

2 6 WS-X4306 JAE053200DD Hw : 2.0

3 34 WS-X4232-L3 JAB053206A6 Hw : 1.7

5 6 WS-X4306 JAE0531036B Hw : 2.0

Following are steps I made to change the VLAN 100 to 300 on a port 3/6

RR14006-I (enable) set vlan 300 3/6 ?

<cr>

RR14006-I (enable) set vlan 300 3/6

2003 Dec 19 05:25:06 %SPANTREE-5-PORTDEL_FAILNOTFOUND: 3/6 in vlan 100 not found

(telnet87)

2003 Dec 19 05:25:06 %SYS-6-CFG_CHG:Module 3 block changed by telnet/172.24.132.

206/

VLAN 300 modified.

VLAN 100 modified.

VLAN Mod/Ports

---- -----------------------

300 2/1-3

3/1-2,3/4,3/6-7,3/10,3/12-13,3/18,3/21,3/26,3/31,3/33

5/1-2

RR14006-I (enable) sh vlan 300

VLAN Name Status IfIndex Mod/Ports, Vlans

---- -------------------------------- --------- ------- ------------------------

300 VLAN0300 active 101 2/1-3

3/1-2,3/4,3/6-7,3/10,3/1

2-13,3/18,3/21,3/26,3/31,3/33

5/1-2

VLAN Type SAID MTU Parent RingNo BrdgNo Stp BrdgMode Trans1 Trans2

---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------

300 enet 100300 1500 - - - - - 0 0

VLAN DynCreated RSPAN

---- ---------- --------

300 static disabled

But still the the port 3/6 is in VLAN 100 , even though it is showing VLAN 300 in the sh vlan command

Can anyone help in this issue

Thanks in advance

Regards

Auromira

1 REPLY
New Member

Re: Regarding changing Port from one VLAN to other VLAN in CISCO

Hi,

is there any trunk configuration about 3/6?

374
Views
0
Helpful
1
Replies
CreatePlease to create content