Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reloading a Cisco 2620

Hello,

I have a Cisco 2620 that we are trying to get running. After attempting to reset the password, the router is acting funny and not accepting a lot of the normal commands.

How do I go about just reinstalling everything as if it were brand new? I have the console cable and can access the router through the console.

Thank you.

1 REPLY
New Member

Re: Reloading a Cisco 2620

Can you be a bit more specific regarding "acting funny"? For instance, can you cut-n-paste the commands you type and the response that you get from the router?

You can set it back to factory by doing the following:

Router> enable

Router# write erase

Router# reload

This will erase your configuration from NVRAM and reload the router back to the factory default.

Mick.

285
Views
0
Helpful
1
Replies