We've got a T1 coming into a cisco 2610 that is then connected to our PIX 501. We have the router configured to let all traffic through and then we block it at the PIX. My question is, this leaves a hole open on our 2610 - that is, outsiders can telnet in and could hack our id and password to easily get access to the 2610. Is there a way to turn off remote administration as a whole? (Make is so that all administration must transpire over the console port.)
If not, whats the easiest way to set up the 2610 to let in all traffice, but the traffic on the telnet port?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...