I know there are a couple of ways to grab the config off a device, but I am looking for a "best practice" process. Any thoughts are much appreciated.
I would like to pull the configs from my 2600 (12.2 IOS) and PIX 515 (6.22) on a regular basis. I would be pulling from a Win2000 server. Ideally, I would like to have this process somewhat automated or at least simple enough that I could have an jr. admin run.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...