07-01-2002 01:42 PM - edited 03-01-2019 11:18 PM
What is the proper configuration to utilize a WIC-1AM on a 2600 series router for
dial-in remote management? DDR not needed. Please assist. Thank you.
CCO mentions that you CAN do this using IOS 12.2.(2)XB, but no config examples are listed.
07-01-2002 04:27 PM
If no DDR needed, don't configure the interface Async x....You just need to configure the line for remote-dialin..
Here is the place which discuss it
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xb/122xb_2/ft12pwic.htm#xtocid2240113
In above link, don't configure the "interface Async x"..Thanks..Tejal
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community