Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

efl
New Member

Remote Managament (Out-of-band) using WIC-1AM on 2600 router

What is the proper configuration to utilize a WIC-1AM on a 2600 series router for

dial-in remote management? DDR not needed. Please assist. Thank you.

CCO mentions that you CAN do this using IOS 12.2.(2)XB, but no config examples are listed.

1 REPLY
Cisco Employee

Re: Remote Managament (Out-of-band) using WIC-1AM on 2600 router

If no DDR needed, don't configure the interface Async x....You just need to configure the line for remote-dialin..

Here is the place which discuss it

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xb/122xb_2/ft12pwic.htm#xtocid2240113

In above link, don't configure the "interface Async x"..Thanks..Tejal

162
Views
0
Helpful
1
Replies
CreatePlease login to create content