Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Remote management of Cisco 831

The Cisco 831 has the capibility of remote management but it appears to me that this only applies to the CLI. When I attempted to browse into the 831 I was prompted for a username/password, which I gave, then was prompted for a firewall username/password, which I had not setup in the 831. At this point I selected no and it appeared that I was just 'looping' getting no where.

Question - Should I be able to browse into the 831 without a firewall?

The reasoning for my inquires is that we are going to deploy some 831's to replace Cisco 3002 Hardware clients in the field and I was wanting to see what kind of remote capibilities I would have. The 3002 do not support the IP phones very well due to the lack of QoS and the 831 do.

2 REPLIES
Bronze

Re: Remote management of Cisco 831

I am not sure whether you are using the CRWS tool to manage the router. If so, this link has some information on troubleshooting using this tool. Check it out :

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/831/hwins/install.htm#89434

New Member

Re: Remote management of Cisco 831

Thanks, I had already read that information. What I was looking for was information on remote managing the 831 via the internet.

77
Views
0
Helpful
2
Replies
CreatePlease login to create content