Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

remove ip nat entry???

I need to remove an entry that is forwarding all traffic to an insde ip address.

ex -

ip nat inside source static 192.168.0.10 208.B.C.D

The problem is that I need to block some ports. I know how to set up the entry but not how to remove one.

Thanks

4 REPLIES
New Member

Re: remove ip nat entry???

Like all cisco IO commands can be negated by puttin a "no" in front of it:

no ip nat inside source static 192.168.0.10 208.B.C.D

HTH

Fabio

New Member

Re: remove ip nat entry???

Thanks

Robert

New Member

Re: remove ip nat entry???

HI

clear ip nat translation *

NIX Technical

Mohsen.

Silver

Re: remove ip nat entry???

If this static entry is in use you won't be able to remove it . I recommend to perform a configuration script:

clear ip nat trans * \* this clears entire NAT table*\

config t

no ip nat inside source static 192.168.0.10 208.B.C.D

exit

Performing this script assures that after clearing NAT table you can remove ip nat command before this translation install again in the table.

300
Views
0
Helpful
4
Replies