Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Removing config of removed module from running-config on CatIOS

Hi,

have Cat6500 running Native IOS. If I remove a Ethernet-switching-module from the chassis the

config for the interfaces on this module is still present in the running-config. Is there any possibility to remove this part of the config without restarting the box.

(on CatOS there was available the "clear config <module-nr>" command.

Thanks in Advance

1 REPLY
Silver

Re: Removing config of removed module from running-config on Cat

I too searched through command references and navigated through 6509 IOS CLI but could not find equivalent command "clear config " of CatOS. I think it is not supported at present. Only option is to reload the switch.

101
Views
0
Helpful
1
Replies