I have build a etherchannel between Cat 5500 and 3524 XL switch. Channel works fine, but when I want to tear down the channel at 5500, the channel configuration will not go away. I turned the mode to auto...as defined on CCO, to see if the channel breaks down in 2 min. or so. But the 'show port channel" still shows the bundle. Moreover, just for testing purpose, I tried moving one of the channel ports to other vlan, the bundle moves as a whole but not independently. This means that the ether channel bundle is still there.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...