Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

removing etherchannel bundle on catalyst 5500

I have build a etherchannel between Cat 5500 and 3524 XL switch. Channel works fine, but when I want to tear down the channel at 5500, the channel configuration will not go away. I turned the mode to auto...as defined on CCO, to see if the channel breaks down in 2 min. or so. But the 'show port channel" still shows the bundle. Moreover, just for testing purpose, I tried moving one of the channel ports to other vlan, the bundle moves as a whole but not independently. This means that the ether channel bundle is still there.

1 REPLY
Anonymous
N/A

Re: removing etherchannel bundle on catalyst 5500

please turn the mode off for the channel. auto should also work as this is connected to the 3500XL switch.

108
Views
0
Helpful
1
Replies
CreatePlease to create content