As part of an IP conversion, we switched previous primary VLAN interface IP's to secondary in a Dual MSFC/HSRP environment. We are ready to remove those secondary IP's from this environment. Issuing the command "no standby 15 ip 22.214.171.124 secondary" has no effect. TAC is recommending blowing away the entire config and rebuilding. Problem is, this is a production environment, and that just can't happen. Anybody seen this before where a router accepts the command, but it doesn't take effect in the config?
I just tried with an MSFC running 12.1(8a)E5 and did not find the issue. I found some bugs in older IOS and the workaround was to use no command without the IP address. Try "no standby 15 ip" and put back the standby 15 again
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...