Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

removing statement on 2948GL3

I cant seem to remove the statement ' mls rp vlan-id 20 '

I have tried 'no' and even then doing a wr mem then reloading but still nothing, any ideas. I want to change it to vlan-id 10.

3 REPLIES
New Member

Re: removing statement on 2948GL3

Configure the interface to be the mls rp management interface and then you should be able to remove the statement.

interface FastEthernet43

no ip address

no ip directed-broadcast

shutdown

mls rp vlan-id 3

mls rp management-interface

end

Router#config t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#int fa43

Router(config-if)#no mls rp vlan-id 3

Router(config-if)#no mls rp management-interface

Router(config-if)#end

Router#sh run

1w6d: %SYS-5-CONFIG_I: Configured from console by console int fa43

Building configuration...

Current configuration:

!

interface FastEthernet43

no ip address

no ip directed-broadcast

shutdown

end

Router#

New Member

Re: removing statement on 2948GL3

Thanks a lot, thats done the trick. What function does that management interface command have?

New Member

Re: removing statement on 2948GL3

Hi,

MLSP packets are sent and received through the management interface.

For config MLS on a router, please refer to the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_4_5/config/mls.htm#xtocid1626622

Understanding and configuring MLS:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_4_5/config/mls.htm

Thanks,

Nash

127
Views
0
Helpful
3
Replies
CreatePlease to create content