We have 2 3750 switches in a stack and need to replace both of them. Has anyone done this before? What would be the best way to get the config so that it matches both switches? Should I replace one at a time? I know one will be designated a master, anything to consider on that? Any help would be great.
Probably the best way is to pre-configure the new switches and then link them to the existing network. This can be done via 100Mb crossover if needed as it will be a temporary situation.
After this link is established you may start plugging the PC's and server over to the new switches. As a last step you can then remove the old switches. The operation might be a bit more difficult if there is insufficient rack space but that is always a matter of improvisation. Good luck!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.