Replacing a Shiva Terminal Server with Cisco Async port?
We have numerous old Shiva terminal Servers in use that are used to connect dumb terminals to an IP based hosts system, basically the TS is used to create a telnet session for each connected dumb terminal.
Can I configure a cisco async port (Aux for testing before purchasing a NM-8a) to do the same?
i.e I want to connect a dumb terminal to the AUX port ion order to bring up a telnet session to the remote node.
Re: Replacing a Shiva Terminal Server with Cisco Async port?
Sure; the simplist means would be with a simple "autocommand telnet x.x.x.x" command user the line; the dumb terminal would enter a CR (the activation character is configurable), and the telnet session would be automatically built. There are other commands under the line that can allow you to control access to the line, timeouts on the line, etc.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...