Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Replacing cisco 1603 with 2612.

at present the set up is :256K cct ------MUX-------IN -------OUT------(4) RJ45 VOICE PORTS.

FROM OUT :wan connection to Cisco 1603 router.

what the customer wants is:

maintain the voice mux.

can I replace the 1603 ,with 2612.? will the mux need to be configured ?

will the voice call be affected.?

Thanks

Sam

1 REPLY

Re: Replacing cisco 1603 with 2612.

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

91
Views
0
Helpful
1
Replies
CreatePlease to create content