Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Bronze

Replacing faulty sup720

Sup720 did not pass diag tests. Need to replace it. Are there any special instructions to replace faulty sup720? Only one sup720 (6513,IOS), no redundant sup.

Thanks.

1 REPLY
Cisco Employee

Re: Replacing faulty sup720

If you have your configuration backed up already, then all you should need to do is power down the switch (since we don't have redundant sups), insert the replacement supervisor, power the switch up, ensure that you are running the desired IOS version, and then load your config from a flash device or TFTP server.

HTH,

Bobby

*Please rate helpful posts.

262
Views
5
Helpful
1
Replies
CreatePlease to create content