Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reserved B-channels with PRI and rotary-group

I have a 2600 router with ISDN PRI and 1 serial Interface. Approx. 150 Clients are connecting to the PRI. In case of a serial link failure there should be ISDN-Backup (2 B-Channels) over the same PRI the Clients are connecting to.

Is there a possibility to configure a rotary-group but give the 2 B-Channels (needed for backing up the serial line) priority over the others? Like if all 30 channels are in use by some clients to drop 2 channels and use them for the backup.

With dialer-profiles I could reserve 2 channels for the backup but I want to avoid configuring 150 dialer-interfaces.

1 REPLY
Anonymous
N/A

Re: reserved B-channels with PRI and rotary-group

There is no way to prioritize dialer

maps that will cause existing connections

to be torn down. The best that I can

suggest is you try the command ,

which will cause the fast-idle timer to be

used instead of the idle-timer in the

event that all links are used and we need

to dial out to a new site. If the existing links

still have interesting data, you may not

see a disconnect right away. You could set the

fast-idle to a low value (like 5), but

beware that this may cause more than just

2 links to drop.

88
Views
0
Helpful
1
Replies
CreatePlease to create content