Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Reset a line interface on a 26xx router

I have a router 2611 with the Serial module 8S/A which runs the IOS vers. 12.2.7. I configure a line interface associated with it corresponding async interface. For a special reason I have to erase all command line under the line int. It's running fine with the command "default int serialx/x".

I want to do the same thing on a 2620 router with the 16 async ports module and IOS vers 12.2.7. In that situation the result of the "default int asyn x/x" is not it wanted.

Is there a command to completely reset the line interface ?

1 REPLY
Anonymous
N/A

Re: Reset a line interface on a 26xx router

The default command does not apply to

async-interfaces (as opposed to serial

interfaces set up as async)...

90
Views
0
Helpful
1
Replies