Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Reset DSP on 3600

How to reset DSP on the 2600 and 3600 without reset the controller or reset the routers.

2 REPLIES
Anonymous
N/A

Re: Reset DSP on 3600

Most cases, the best practice is to reset the box or

controller for dsp reset but you can use this

few methods too.

1. go unto the voice-port and do a shutdown, no shutdown.

this will reset the dsp used by that particular voice port

2.go to the voice port and do a busyout forced and no busyout forced.

This too will reset the dsp per voice-port

3.go under the controller for cas trunks and do

ds0 busyout 1-24 & no ds0 busyout 1-24, this will rest the dsp based on the timeslot

specified.

New Member

Reset DSP on 3600

Hi,

you can also issue the  test dsp device [SLOT ID] [DSP ID, all] reset    command under priviledge exec mode. Afeter that, the RST count on the sh voice dsp command should increase by one.

    Besr regards.

4621
Views
0
Helpful
2
Replies
CreatePlease to create content