Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Reset DSP on 3600

How to reset DSP on the 2600 and 3600 without reset the controller or reset the routers.

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: Reset DSP on 3600

Most cases, the best practice is to reset the box or

controller for dsp reset but you can use this

few methods too.

1. go unto the voice-port and do a shutdown, no shutdown.

this will reset the dsp used by that particular voice port

2.go to the voice port and do a busyout forced and no busyout forced.

This too will reset the dsp per voice-port

3.go under the controller for cas trunks and do

ds0 busyout 1-24 & no ds0 busyout 1-24, this will rest the dsp based on the timeslot

specified.

101
Views
0
Helpful
1
Replies