Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Reshut of vlans needed (6513 with 2 sups+MSFC)

After a replacement of our MSFC we had an odd problem:

Both MSFC1 and MSFC2 synchronised so the configurations are exactly the same. The only problem is when we look to our standy brief output both MSFC's will not see each other (standby address unknown)

only after a shutdown and a no shutdown command on our vlans on MSFC the same vlan on MSFC2 will com up.

Has somebody seen this problem before ????

we are using 12.1(3a)E4 on our MSFC's and 7.6(1) on our Catalyst 6513

1 REPLY
Silver

Re: Reshut of vlans needed (6513 with 2 sups+MSFC)

Refer the below link for verifying the standby status. Also thsi link has the information to implemet in hybrid moede.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00800c65e8.html#1019915

108
Views
0
Helpful
1
Replies