Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Restricting inbound and outbound traffic

I wonder if it is possible to configura a serial port on 3640 router that inbound traffic will use 75% of bandwitdh and outbound will use 25% of band width.

If so is it possible to send me a sample configuration.

2 REPLIES
Bronze

Re: Restricting inbound and outbound traffic

What are you trying to accomplish? A serial port is full-duplex, meaning that if the line speed is x, then you have x bandwidth available for transmit and x bandwidth available for receive. The bandwidth you give to one does not take away bandwidth from the other.

HTH

Mark

New Member

Re: Restricting inbound and outbound traffic

No its not possible to do it as told above. Incase you have a 2 Mb link, you get 2 Mb input and 2 Mb output rate.

You can restrict input or output traffic rate independently by configuring CAR.Check out this doc:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c75ce.html

103
Views
0
Helpful
2
Replies
CreatePlease to create content