does anyone know how to restrict dial up users for using multilink PPP based on their RADIUS profile?? We are using RADIUS from Potal and AS5300 running 12.2(5) (c5300-is-mz.122-5.bin). I have tested using local authentication succesfully, but when a turn aaa to RADIUS, it doesnt work. Only is possible to get one connection. This is the aaa config of my Access Server:
aaa group server radius MODEMS
server ip_radius_server_1 auth-port 1645 acct-port 1646
server ip_radius_server_2 auth-port 1645 acct-port 1646
aaa authentication ppp default group MODEMS none
aaa authorization exec default local none
aaa authorization network default group MODEMS none
aaa authorization network restricted group radius
aaa accounting delay-start
aaa accounting update newinfo
aaa accounting network default start-stop group MODEMS
aaa accounting connection default start-stop group MODEMS
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...