Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
yeo
Community Member

Retrieving access-list counts with SNMP

Looking at doing some poor mans accounting. After setting up an access-list such as:

ip access-list extended test

permit udp any host 192.168.1.50 eq domain

perimt udp any host 192.168.1.51 eq domain

permit ip any any

These lists would produce counts associated with the traffic that matches the list. As long as you don't mind the overhead, you get accurate traffic numbers. I was wondering if any one know how to retreive this information via SNMP. For use with a program like MRTG or CACTI. IF any one can point me in the right direction I would greatly appreciate it.

Thanks,

Kevin Hutton

1 REPLY
Blue

Re: Retrieving access-list counts with SNMP

There are no SNMP MIBs for access-list count

97
Views
0
Helpful
1
Replies
CreatePlease to create content