Reverse Logic for BRI interfaces in DFM vs. Serial
Right now, I get a problem for both Serial and BRI interfaces being down on all my routers. I use the BRI interface exclusively as a backup device for an ISDN connection when the serial interface is down. How can I get DFM to report there is a problem with a BRI interface being up instead of down? I'd also like to get a resolution for the BRI connection going down to clear out the BRI up message on the Monitoring Console.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...