Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reverse route

I have a setup as shown below.

Internet clients --> Site A FW--> Site A L3 Switch -->L3 Switch Site B--> Servers

Site B has a default route pointing to another FW at SiteB. I have to enable NAT on FW of SiteA in order in order for internet clients to reach to my server at SiteB is there a way where in i can do a config on SiteB L3 device so the reverse traffic for internet reaches back to SiteA FW and i don't have to NAT the connection on SiteA FW. I hope i am making sense to you guys. I have attached the diagram of network also.

L3 model at both site is cisco 3750 switch

 

1 REPLY
New Member

Guys can some help me on this

Guys can some help me on this can i achieve this by implementing PBR

54
Views
0
Helpful
1
Replies