Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Reverse Telnet Aux

Hello

I searched about this topic and i tried all configurations , which i found, but it doesn't work. Maybe you can help me ? 

Ok, my hardware: two routers, both got a "wr erase"  and i only configurated the hostname.  Then i configurated the 2610 for a reverse telnet session.

I am connected with a console cable from pc in the console port ( blue ), configuration via hyperterminal  . Then i connected the router from Aux Port with a straight through patch cable to a Cisco 876 Router in the Console Port .   I tried a telnet but i don't see more than this

Trying 10.0.0.1, 2065 ... Open

Configuration Cisco 2610

Interface                  IP-Address      OK? Method Status                Protocol
FastEthernet0/0            unassigned      YES NVRAM  administratively down down   
Serial0/0                  unassigned      YES NVRAM  administratively down down   
Loopback0                  10.0.0.1        YES manual up                    up

   Tty Typ     Tx/Rx    A Modem  Roty AccO AccI   Uses   Noise  Overruns   Int
*    0 CTY              -    -      -    -    -      0       0     0/0       -
    65 AUX   9600/9600  -    -      -    -    -      0       0     0/0       -
    66 VTY              -    -      -    -    -      0       0     0/0       -
    67 VTY              -    -      -    -    -      0       0     0/0       -
    68 VTY              -    -      -    -    -      0       0     0/0       -
    69 VTY              -    -      -    -    -      0       0     0/0       -
    70 VTY              -    -      -    -    -      0       0     0/0       -

Line(s) not in async mode -or- with no hardware support:
1-64


Current configuration : 653 bytes

....

!
line con 0
line aux 0
modem InOut
transport input all
line vty 0 4
login
!
!
!
end


Test_Cisco2610#telnet 10.0.0.1 2065
Trying 10.0.0.1, 2065 ... Open

and not more.

Are there any configurations , which i should do on the 876 ?. Any ideas ? .

best regards

Sebastian

446
Views
0
Helpful
0
Replies
CreatePlease to create content