Assuming your switch is Cisco, the console port should be a dte so the rollover cable should work (router aux is also dte).
Whenever I am having problems with a line that I know should be working, I 'clear line aux 0' or 'clear line cons 0' as the case may be.
Is it possible that maybe you have a speed mismatch, flow control mismatch, etc. between the aux and the cons? All that is required for the "open" message to appear is for the telnet to be successful. There is no requirement that the physical interface be setup correctly.
clear line didn't solve the problem, my router is a 3620 how can i now if the remote user didn't switch the cable connection on router aux - console, because the cisco is near a wall and he can't check it...
I think the activation character is on the way in not on the way out. Bottom line - you have a physical connectivity problem at the distant end that needs resolved. I pasted you original config into an aux port and plugged in a rollover cable. No problems.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.