Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Cisco Employee

Reverse Telnet to Modem port,

I am trying to figure a way to use a virtual interface, or rotary type config on a 3640 to do reverse telnet to the next available modem port, instead of specifying a specific modem port, and then issue AT commands to dial a pager.

2 REPLIES
Bronze

Re: Reverse Telnet to Modem port,

Put the command "rotary x" (where x is a number like 1, 2 etc) under the tty lines and then reverse telnet to port 7000+x . If that does not work, try rev. telnetting to 3000+x.

Cisco Employee

Re: Reverse Telnet to Modem port,

Thanks, worked like a champ!

118
Views
0
Helpful
2
Replies
CreatePlease to create content