I have several devices connected to a wire, let's say 18.104.22.168/25. There's RIP configured among them, that way:
One of the devices, 22.214.171.124, has a static route like this:
ip route 0.0.0.0 0.0.0.0 126.96.36.199
The thing is that this route points to 188.8.131.52, and so, if I am not wrong, rip won't redistribute it though the ethernet (though being a static route and having redistribute static in the conf) for the destination belongs to the own 184.108.40.206 network. And that's what happens in my Lab.
But the surprise comes at customer's site where 220.127.116.11 has an entry for 0.0.0.0 learned via RIP from 18.104.22.168 !!!
I wonder if there is any configuration that could make it happen, taking into account that RIP configuration is exactly as I depicted before.
You can verify whether split-horizon is enabled or disabled on the ethernet interface of the device 22.214.171.124 . But, even if split-horizon is disabled, I guess you should not see this route on 126.96.36.199 though it may be installed on other routers belonging to the same ethernet segment 188.8.131.52/25, since the next-hop advertised by 184.108.40.206 in the RIP update will be pointing to 220.127.116.11. You can use the 'debug ip rip' commands on both the routers to see the RIP routes being advertised and received by them. This will help you find what is happening.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...