Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RIP timers for Cisco-Nortel

Anyone know what should be the RIP timers(in cisco) set to when connected to the bay routers for best convergence.

4 REPLIES

Re: RIP timers for Cisco-Nortel

On both the Cisco and Bay, 30 seconds is the default for updates.

On Bay, 90 seconds in the default for the hold time and invalid. Cisco's default is 180 seconds for these 2 in 12.2(2)T code.

Ideally, the timers should match on all the routers.

New Member

Re: RIP timers for Cisco-Nortel

Is there a flash timer for nortel? If not then when will it remove the route?

amdcent

Re: RIP timers for Cisco-Nortel

Yes. In BayRS its called the timeout timer.

So, here are the times in BayRS:

30 sec -- Updates

90 sec -- timeout (this is called invalid in SM)

90 sec -- hold down

In cisco, do 'show ip proto' to see timers.

New Member

Re: RIP timers for Cisco-Nortel

Thanks

amdcent

201
Views
0
Helpful
4
Replies
CreatePlease to create content