Have CW2K running on W2K with RME 3.2. When trying to do an image upgrade to Cat 3500XL and 2900XL switches I get errors cant telnet to device.
I then atttempt code upgrade to same device again and it will work. Sometimes it takes 4 or 5 attempts or more and happens on all switches. I know telnet passwords are correct because I can telnet to all switches from a DOS prompt using same password at ant time. TAC has been working on this with no success. Thanks
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...