Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RME 3.3 and modular devices

Is it possible to configure modules (e.g. OC12 modules) on devices through config editor or NetConfig(i.e. modules that require the "session

command"). I have tried various methods with no joy.

Also can you use SWIM to upgrade images on modules as well as the chassis, if so how? I cannot find any pertinent documentation on CCO to indicate this type of management of device modules.

Thanks in advance

Nick :-)

1 REPLY
Blue

Re: RME 3.3 and modular devices

If the commands are interactive which require additional user input like Y/N, then it may not be possible. As for the SWIM, take a look at the Supported device list for RME which as a list of devices that can be upgraded using SWIM.

108
Views
0
Helpful
1
Replies
CreatePlease to create content