Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RME 3.3 upgrade - dmgtd stop problem

After upgrading to CD1 4th edition and RME 3.3 on Solaris 2.6 get the following error message when doing /etc/init.d/dmgtd stop.

Error: connect to dmgtd process on "127.0.0.1" on port 42340 failed.

Also get this error message when running pdshow! Yet CiscoWorks is running and looks OK.

  • Other Network Infrastructure Subjects
1 REPLY

Re: RME 3.3 upgrade - dmgtd stop problem

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

120
Views
0
Helpful
1
Replies
This widget could not be displayed.