Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Silver

RME 3.4 and PIX 515E

I have a PIX 515E running 6.2(2). RME 3.4 has been set up to manage this device. Since adding the device to RME, it has added the "no pager" command to the PIX's configuration. Therefore, when issuing a "wr t" (for example), then the whole configuration scrolls without the "More..." prompt. If the pager command is reconfigured manually to the default, then this stays in place until the next time RME accesses the device to retrieve the configuration. Is this a known issue?

2 REPLIES
Blue

Re: RME 3.4 and PIX 515E

Have a look at CSCeb06859

Silver

Re: RME 3.4 and PIX 515E

Thanks. I found CSCdy13889 which described the problem but was in a "closed" state, which now makes sense if the fault is with the PIX code rather than RME.

81
Views
0
Helpful
2
Replies
CreatePlease to create content